Raspberry Pi B+ Black Case
*Raspberry Pi 3 compatible.
Step 1: Remove the Masking
All of the acrylic components have a brown paper masking on them. You will need to remove it to make the parts fit together nicely. It is best to start at a corner.
Make sure to remove the mask from both sides
Step 2: Attach the delrin clips
Take the top panel and the two delrin clips and set them out as shown in the image above.
Snap the delrin clips in place as shown above
Step 3: Mount the PCB
Take the Raspberry Pi and mount it in place as shown in the images above.
Step 4: Place the Pi on the bottom panel
Step 5: Put the SD Card side in place
Step 6: Put the USB/Ethernet side in place
Step 7: Attach the Top Panel
Step 8: Snap the Power/HDMI/Audio side into place
Step 9: Snap the I/O side in place
CONGRATULATIONS! You now have a fully assembled Raspberry Pi B+ Black Case!