Banana Pi Case

IMG_4347

IMG_4295

Step 1: Remove the Masking

IMG_4297

All of the acrylic components have a brown paper masking on them. You will need to remove it to make the parts fit together nicely. It is best to start at a corner.

IMG_4299

Make sure to remove the mask from both sides

IMG_4301

Step 2: Attach the delrin clips to the PCB

The clip with IR etched in it goes on the side with the infrared receiver and the loop clip with IR etched on it goes next to the IR sensor.

IMG_4306 IMG_4307IMG_4312

The Clip with a corner cut out goes over the SATA power connectorIMG_4305IMG_4314

Step 3: Attach the top plate

Line up the ribbon cable slots in the top panel and push it down onto the clips.

IMG_4315

Step 4: Set the PCB on the bottom panel

IMG_4318 IMG_4319

Step 5: Put the SD Card side in place

IMG_4321 IMG_4323

Step 6: Put the USB/Ethernet side in place

IMG_4326 IMG_4327

Step 7: Snap the Power/HDMI/SATA side into place

IMG_4329 IMG_4331

Step 8: Snap the Composite Video/Audio side in place

IMG_4334 IMG_4336

Step 9: Attach the button clip

IMG_4345 IMG_4347 IMG_4350

Congratulations! You are done.

IMG_4343 IMG_4340 IMG_4339

 

Want one of these cases for yourself? Grab one here:
http://www.storenvy.com/products/12507294-banana-pi-case

Want the design files? Grab them from my Thingiverse page:
http://www.thingiverse.com/thing:727982

Share