Built to Spec

 

Grab a kit of this case from our store or grab the design files if you want to make your own or modify it!

Step 1: Remove the Masking

All of the acrylic components have a brown paper masking on them. You will need to remove it to make the parts fit together nicely. It is best to start at a corner.

Make sure to remove the mask from both sides

Step 2: Attach the delrin clips

Step 3: Place the Pi on the bottom panel

Step 4: Put the USB side in place

Step 5: Put the SD Card side in place

Step 6: Snap the Power/HDMI/Audio side into place

Step 7: Snap the I/O side in place

CONGRATULATIONS! You now have a fully assembled Raspberry Pi A+ Clear Case!