Built to Spec

*Raspberry Pi 3 compatible.

Grab a kit of this case from our store or grab the design files if you want to make your own or modify it!

This Case is designed to work with both the A+ and B+ models of the Raspberry Pi

Step 1: Remove the Masking

All of the acrylic components have a brown paper masking on them. You will need to remove it to make the parts fit together nicely. It is best to start at a corner.

Make sure to remove the mask from both sides

 

Step 2: Attach the delrin clips and LCD PCB

Snap the delrin clips in place and install the LCD PCB as shown above

Step 3: Insert the Buttons into the Top Panel

Step 4: Put the USB/Ethernet side in place

Step 5: Put the SD Card side in place

Step 6: Place the Pi in Place

Step 7: Attach the Bottom Panel

 

At this point you can now flip the case over

 Step 8: Snap the Power/HDMI/Audio side into place

Step 11: Snap the I/O side in place

CONGRATULATIONS! You now have a fully assembled Raspberry Pi A+/B+ Adafruit LCD Case!

If you are using this case with the Raspberry Pi A+, simply change out the USB/Ethernet sides.